1 / 3
Airplane Sky Banner Business Card Holder — zdjęcie 1
1 / 3

Airplane Sky Banner Business Card Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A flying airplane business card display. Take your business to new heights!

Ocena
4,75 / 5
Polubienia
178
Pobrania
400
Wydruki
5
Wyświetlenia
2363
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

A “flying” airplane business card holder display with spinning propeller! Holds standard business card sizes.

  • Designed from scratch in Fusion 360
  • Printed in PLA
    • 4mm nozzle
    • 0.2 mm layer height
    • Supports as shown below

 

Print Instructions

Print components in the orientations as shown (split up the print for different filaments if you need to)

Notes:

  • The clouds and support bar have a flat side. Make sure that side is face down on the bed!
  • The only supports necessary should be the main wings on the plane
  • Each component should print QTY 1 EXCEPT for the Plane Card Clip, which should be QTY 2

First layer squish may need to be trimmed away from several components, mainly the cloud tabs (don't trim away too much, the fit may be too loose!), base, plane nose (trim away any excess from the front hole), and plane body.

 

Assembly Instructions

 

Step 1: Insert cloud pieces into base. Be sure to face the flat side forward, and trim away any excess that causes a poor fit.

 


Step 2: Insert the support bar into the base as shown. Note that only one side (the slightly thicker side) will clip in properly.

 

Step 3: Cut a piece of 1.75mm filament, about 16mm long, and insert it into the plane nose cap (may need to trim around the hole to open it up). Add the propeller

 

Step 4: Press the filament into the hole at the front of the plane as shown (may need to trim around the hole to open it up)

 

Step 5: Cut two pieces of 1.75mm filament, each around 52mm long. Insert a piece of filament into each card clip

 

Step 6: Insert these into the rear of the plane in the orientation shown

 

Step 7: Clip the plane onto the support bar

 

Step 8: Add your cards, and the assembly is complete!

 

Notes:

Thanks for taking a look at my model! Hope you enjoy!
This model took around 5-6 hours to model, definitely faster than my last one. I still have a lot to learn, so feedback is appreciated!

Tagi