Braces for IKEA LACK tables
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adds rigidity to LACK tables
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 177
- Wydruki
- 8
- Wyświetlenia
- 664
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Simple and low profile brace to add rigidity to your lack tables.
Added 3x countersunk bores. To be secured to the legs and under table surface.
Screw size recommendation:
I use M4 countersunk self driving screws for my Lack table. It was not seated flush to the surface after tightening, hence, I recommend the use of M3.5 screws instead.
For my American friends, Size #6 to #8 screws will do the job fine.
Assembly:
No drilling of pilot hole is required, no clamps needed. Just a good old screwdriver. Hold it down and into the edge of the table legs, and secure the single hole located on the under table surface first to lock it it place.
Followed by securing the remaining 2 holes located at the legs. secure till printed part is flush with the leg surface.