1 / 1
YALPS - Yet another lab power supply based on DPS3005 and ender 3 24V original power supply
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lab power supply based on DPS3005 and original ender 3 power supply. With up to 24V.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 514
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (11)Powiązane
So I didn't want to go ATX they are just 12V and since I've replaced my ender supply for MeanWell I've decided to put the old supply to good use.
It's designed to print on face with no supports. There are legs at the bottom to make it directed towards the user and at the bottom there's a hole to feed power cable.
You'll need:
- Ender 3 original power supply
- 4 x 6mm banana sockets
- DPS3005
- Bunch of wires
Space to solder bananas (when they are in) is rather small so what I did was presolder each banana with ~5cm wires, put bananas in place and then solder the wires where they belong.