1 / 1
YALPS - Yet another lab power supply based on DPS3005 and ender 3 24V original power supply
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lab power supply based on DPS3005 and original ender 3 power supply. With up to 24V.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 33
- Makes
- 0
- Views
- 512
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
So I didn't want to go ATX they are just 12V and since I've replaced my ender supply for MeanWell I've decided to put the old supply to good use.
It's designed to print on face with no supports. There are legs at the bottom to make it directed towards the user and at the bottom there's a hole to feed power cable.
You'll need:
- Ender 3 original power supply
- 4 x 6mm banana sockets
- DPS3005
- Bunch of wires
Space to solder bananas (when they are in) is rather small so what I did was presolder each banana with ~5cm wires, put bananas in place and then solder the wires where they belong.