Airsoft Hi-capa stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of a simple airsoft pistol holder, I modified the original design to fit Hi-capas
- Ocena
- 4,667 / 5
- Polubienia
- 40
- Pobrania
- 352
- Wydruki
- 3
- Wyświetlenia
- 1331
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I recently purchased an airsoft replica of a 3.8 Vorsk Hi-capa and I obviously wanted to display it.
Found the stand made by @CedricD, but it isn't intended for the Hi-capa platform. So I decided to remix his design. I also took the dimensions of the mag on the second model made by @Trollmaster_LP.
Overall, the design is pretty much the same, I just widened the part where the mag sits.
Dimensions of the mag : 23.20*36.14*50 mm
Print Instructions :
Prints as displayed
I used my Anycubic Kobra, and it took around 3h with these settings :
Supports : no
Rafts : if your bed isn't really sticky
Layer height : 0.28
Infill : 15%
Perimeters : 3
Bottom and top layer : 3
Print speed : 70 mm/s²