Airsoft Hi-capa stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of a simple airsoft pistol holder, I modified the original design to fit Hi-capas
- Rating
- 4.667 / 5
- Likes
- 40
- Downloads
- 352
- Makes
- 3
- Views
- 1,331
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I recently purchased an airsoft replica of a 3.8 Vorsk Hi-capa and I obviously wanted to display it.
Found the stand made by @CedricD, but it isn't intended for the Hi-capa platform. So I decided to remix his design. I also took the dimensions of the mag on the second model made by @Trollmaster_LP.
Overall, the design is pretty much the same, I just widened the part where the mag sits.
Dimensions of the mag : 23.20*36.14*50 mm
Print Instructions :
Prints as displayed
I used my Anycubic Kobra, and it took around 3h with these settings :
Supports : no
Rafts : if your bed isn't really sticky
Layer height : 0.28
Infill : 15%
Perimeters : 3
Bottom and top layer : 3
Print speed : 70 mm/s²