VersaTrack Bracket for 12mm or 1/2" plywood
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Base Bracket for my slew of plates and adapters for the VersaTrack System.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 387
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Recently added some Craftsman VersaTrack to my shop for my reloading station, but wanted to design something custom to hold the dies, as well as other pieces that I'd like to install on the rack.
Designed these brackets to use ¼-20 socket cap screws to clamp the wood (or 3DP'd) part to maintain a lot of flexibility in the design.
If you wanted to attach just a piece of wood to them, or design a corresponding part, the locating hole is 9mm from the edge, and I used a .28" hole (~7.1mm) for the bolt to be installed through (see attached image).
