Desktop Case for 800x480 5" Touchscreen
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I got a 800x480 5" Touchscreen as additional interface for my octoprint raspberry. Also I wanted the option to use it…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 193
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I got a 800x480 5" Touchscreen as additional interface for my octoprint raspberry. Also I wanted the option to use it as a always on monitor for a CCTV.
This is a simple stand, printable without supports. I used M3 nut inserts by ruthex to screw the parts together. There are two throughholes for a cable tie and an indent for a magnet, to secure cables and make it stick to a metallic surface.
The Display is mounted upside down, so the output of the raspberry has to be turned by 180°.
Parts needed:
- 6 M3 nut inserts (or make the holes a bit smaller so that you can screw directly into the plastic)
- 90° HDMI plug male/female
- 2x 90° MicroUSB for power and touch interface
The stand angle and almost all sizes are easy changeable. I'm just a beginner, but I think I created all measurements in dependence of the dummy-PCB-body inside fusion, so changing the PCB sketch should change all other measurements.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15
Filament: Nunus ABS Pink
Notes:
This is an easy print und should work fine on almost all printers.
I printed the bezel face down and flat, the backplate with the outer shell on the bed and flat. The stand is printed on its side.
Category: Electronics