1 / 7
Minimalist Samla 22L and 65L filament storage remix (screwless and structural reinforcement)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I did not want to drill my airtight samla boxes and my spools were too heavy, here is my proposal.
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 168
- Wydruki
- 3
- Wyświetlenia
- 1991
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (8)Wydruki i komentarze (Wydruki: 3) (Komentarze: 8)Remiksy (0)Kolekcje (76)Powiązane
Instructions
For each samla box, print:
- 2x stand leg
- 2x stand leg mirrored
- 2x structures
For a 4 spools air-tight box you will also need from other sources:
| Quantity | Item | Comment |
| 20 | Printed washers | |
| 6 | M8 washers | Can be replaced with 12x printed washers previously mentionned |
| 20 | Printed quick release clips | |
| 16 | 608 bearings | |
| 1 | 1m M8 threaded rod | About 340mm cut for 22l and about 470mm cut for 65l |
| 10 | Ikea Samla clips (I love this hinged one) | |
| 4 | PC4-M6 with 4 of this pass-throught Or PC4-M10 with 4 of this pass-throught | |
| 4 | Ptfe tube about 200mm | Sized to your filament diameter or above |
| 4 | Ptfe tube caps like these | |
| 1 | Door/windows foam seal tape. About 1500mm for 22l, 2000mm for 45-65l | Rubber type preferred |
Note
Tested with ikea samla box 22l and 65l (take the v2.0 of the stand leg for the 65l)
Two versions are available for the 8 mm stand leg:
- Open version (clipsable)
- Fully closed if needed (optional)
I used double side adhesive tape for the stand legs on two sides (optional) but the preholes (improved) for the screws are still available if needed
Revision history
| Date | Version | Description | Comment |
| 19/01/2023 a.m. | V1.0 | First release | |
| 19/01/2023 p.m. | V1.0 | Update instructions |