Rubber Feet Support for Prusa MK3 by Volan on Thingiverse
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I downloaded the two-screw version posted here but felt that having two screws was overkill.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I downloaded the two-screw version of the foot restrainer Volan posted here but felt that having two screws was overkill, so I went to Thingiverse to get the original one-screw version there. It works just fine but was not simple to install (the two-screw version would also have been difficult to install). First I had to trim off part of the flange of the rubber foot that goes into the 30-30 extrusion so that the drop-in nut would have room to turn freely (see the picture). For the two-screw version opposite sides would have to be trimmed. Next, not having any drop-in nuts I had to find one that I could print for the M3 screw. Effixe has this (https://www.printables.com/model/117699-drop-in-t-nut-3030-profil-m3-m4-m5) which was just what I needed. It worked fine with an M3x12 mm screw. To make assembly easier, I had to push the rubber foot into the restrainer so that the flat of the foot was flush with the bottom of the restrainer. When done, the drop-in nut was attached loosely to the restrainer and aligned so it would go through the slot in the 30-30 extrusion and pushed into the slot. The nut was then turned into its locking position with a small screwdriver and the M3 screw was tightened.