1 / 3
Rubber Feet Support for Prusa MK3 by Volan on Thingiverse — image 1
1 / 3

Rubber Feet Support for Prusa MK3 by Volan on Thingiverse

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I downloaded the two-screw version posted here but felt that having two screws was overkill.

Rating
0 / 5
Likes
0
Downloads
9
Makes
0
Views
142
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution

I downloaded the two-screw version of the foot restrainer Volan posted here but felt that having two screws was overkill, so I went to Thingiverse to get the original one-screw version there.  It works just fine but was not simple to install (the two-screw version would also have been difficult to install).  First I had to trim off part of the flange of the rubber foot that goes into the 30-30 extrusion so that the drop-in nut would have room to turn freely (see the picture).  For the two-screw version opposite sides would have to be trimmed.  Next, not having any drop-in nuts I had to find one that I could print for the M3 screw.  Effixe has this (https://www.printables.com/model/117699-drop-in-t-nut-3030-profil-m3-m4-m5) which was just what I needed.  It worked fine with an M3x12 mm screw.  To make assembly easier, I had to push the rubber foot into the restrainer so that the flat of the foot was flush with the bottom of the restrainer.  When done, the drop-in nut was attached loosely to the restrainer and aligned so it would go through the slot in the 30-30 extrusion and pushed into the slot. The nut was then turned into its locking position with a small screwdriver and the M3 screw was tightened.