Adapter to boxflush mount a ventilation fan to the ceiling.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter block for the Sanivesk integrated ventilation fan
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 226
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
Adapter block for the “https://www.gamma.nl/assortiment/sanivesk-inbouwventilator-standaard-wit-125-mm/p/B118099” Sanivesk intergrated 125mm ventilation fan.
My house has a 124mm pipe which should be 125mm, this makes it that the fan doesnt fit and the next size down (100mm) is too small to do anything. The only practical thing i could do is drop it a bit so i have a “box” extractor fan on the ceiling. Which doesnt look bad in all white.
The fan connects to the adapter block using heat inserts. Holes should be marked before insertion so you know where you have to put them this varies per fan.
Once the heat inserts are in place, remove the fan. Screw the adapter into the ceiling, not forgetting to pass trough the power wire for the fan trough the 5th holle into your conduit, or dropped ceiling.
Screw the fan into the adapter plate, and wire in the fan.
In essence this is a 2 stage'd fastning block.
Printed at 0.24mm layer height, 10% infill, 10 top and bottom layers, ABS, 110C bed, 238C nozzle at 150mm/s. This used about 145M of fillament and took 20hours to print.
On a side note 100% infill at 0.12mm takes 3 days and 17 hours :).
Quite the specific block, for a specific use case. But maybe someone could use this for another extraction fan. As this should work with practically all 125mm fans.