Gridfinity Pressure Fit Magnet Jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A jig to hold your magnets in place for Gridfinity designs where the magnet holes are tight enough to pressure fit
- Ocena
- 4,889 / 5
- Polubienia
- 429
- Pobrania
- 2527
- Wydruki
- 39
- Wyświetlenia
- 13 488
- Oceny
- 36
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Lots of Gridfinity designs don't require glue, they just require a hammer to force the magnet in place. This is a simple jig that will align a magnet perfectly in place, and always in the right polarity. The other end is rounded to make it easier to hit dead on with your hammer or mallet.
-------------
Update 3/22/23 - Added a looser tolerance version for if your printer isn't quite as precise.
-------------
If you need a glue jig, I made a simple one that avoids most of the problems I had with other jigs. Grab it here.