Remarkable module for a pen
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Have you ever wanted to have a pen on the other end of your Remarkable stylus? Now you can thanks to 3D printing.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 1215
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My brother complained that we hadn't found a solution to have a pen on his reMarkable marker for when he needed to sign documents or write on real paper. So I've created this pen holder for Christmas.
It will clip on the end of your reMarkable marker (without the built-in eraser) and allow you to slide in a short pen refill to allow you to use the other end of your marker as a normal pen.
This doesn't interfere with the magnets allowing keeping your marker attached to your reMarkable or with the folio.
I would suggest a small layer height (0.15 mm or smaller) and to avoid crossing perimeters as to avoid as much as possible stringing in the middle of the model. Also if you wish to print the clip and the cap at the same time, have the opening facing one another as to have the best external result.
I've found that printing the pieces vertically, even if slower, give a good resistance to breaking while snapping the holder in place.
Two caps are available, the pointy has a nice stylish touch but might allow the stylus to more easily fall off once you slide your reMarkable in a bag.