NBR Modder Board Front Cover with Vertical Cable Guide/Holder/Stress Relief for Ender 3 S1 Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I combined NBR's Modder Board Front Cover (Extra Clearance Version) with Bananenminister's Vertical Ribbon cable Guide
- Ocena
- 4,75 / 5
- Polubienia
- 26
- Pobrania
- 272
- Wydruki
- 2
- Wyświetlenia
- 2228
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a combination of Nathan Builds Robots('s?) Modder Board Front Cover (extra clearance version) and Bananenminister's vertical ribbon cable guide. NBR's MB Front Cover is mirrored because the hole prevented me from moving the bridge I made to connect it to the guide to the right since it collides with the left-side frame when the extruder is homed. This will work for now.
But yeah, the sharp angle the cable goes on the ender 3 S1 Pro stresses me out.
Update:
I realized that the clamp was pressing the cable against one of the wheels on the extruder. I raised it in V2 and also moved it back a little towards center again. Cable still touches wheels but only lightly instead of being pressed.