Magnetic KitchenAid Accessory Mount - Parametric
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model is a remix of https://www.thingiverse.com/thing:4340836 which itself is a remix of…
- Ocena
- 0 / 5
- Polubienia
- 28
- Pobrania
- 76
- Wydruki
- 1
- Wyświetlenia
- 1301
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is a remix of https://www.thingiverse.com/thing:4340836 which itself is a remix of https://www.thingiverse.com/thing:3252061.
This is a mount for KitchenAid stand mixer accessories which is intended to have an embedded magnet, in order to allow you to attach it to the underside of a magnetic surface--in my case, my microwave.
This model has some parametric variables in case you have a different size or strength magnet and want to adjust. The model as designed fits these magnets from McMaster Carr: https://www.mcmaster.com/5862K111/
My model has been measured and created from scratch and does not actually use any measurements from the originals from which it draws inspiration.
Feel free to Buy Me a Coffee if you like what I've done.
Print instructions
My Slicer project configuration is included as a download for reference, but I printed as follows:
Supports:
Yes - Strongly recommended on obvious overhang
Resolution:
0.2mm
Infill:
5-10%
Filament_material:
Doesn't matter too much. PETG might be better but I used PLA as these don't hold a lot of weight
Notes:
My print project is included to illustrate where I added supports, and it also includes a pause at 6mm in order to allow for embedding of the magnet.