xFlasher Case (USB C)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for the xFlasher 360 Rev B+
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 316
- Wydruki
- 1
- Wyświetlenia
- 1859
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This case was designed for the xFlasher 360 (an all in one Xbox 360 NAND reader/writer)
It was created with injection molding in mind so the tolerances are very tight.
To print this you will need a high resolution SLA printer.
For lower resolution printers try the no clips version of the case. For the no clips version you should add a drop of superglue to each corner of the case and hold until set.
If printing the version with clips you should start with the larger clip and use it as a hinge to lay the top half down. After, firmly press in each of the two smaller clips until the case is fully closed.
For the non USB C version you'll want this case: Original xFlasher case