xFlasher Case (USB C)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for the xFlasher 360 Rev B+
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 316
- Makes
- 1
- Views
- 1,859
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This case was designed for the xFlasher 360 (an all in one Xbox 360 NAND reader/writer)
It was created with injection molding in mind so the tolerances are very tight.
To print this you will need a high resolution SLA printer.
For lower resolution printers try the no clips version of the case. For the no clips version you should add a drop of superglue to each corner of the case and hold until set.
If printing the version with clips you should start with the larger clip and use it as a hinge to lay the top half down. After, firmly press in each of the two smaller clips until the case is fully closed.
For the non USB C version you'll want this case: Original xFlasher case