Router Table Bit Depth Gage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This will accommodate the 3-1/2 in raised panel cutters used on a router table.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 665
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
I needed a depth gage for raised panel bits for easier setup later on my router table. Most all I could buy were too narrow and too shallow. This model is based off using a PEC Tools 6 inch 4R Rigid Certified Rule (402-006CT) . The rule width is 0.717" and thickness is 0.043" This model is based on this size of rule. You may have to modify the slot to fit the ¾" rule you are using. It is captured in place with a cover plate that is held in with (4) #6-19 rolling thread screws for plastic. I only print with PETG but I am sure you can print in any material you desire. This model was printed using 0.2mm Quality print setting with 30% infill. Also included a gage block just for fun. I hope this helps others.