Router Table Bit Depth Gage
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This will accommodate the 3-1/2 in raised panel cutters used on a router table.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 54
- Makes
- 0
- Views
- 665
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
I needed a depth gage for raised panel bits for easier setup later on my router table. Most all I could buy were too narrow and too shallow. This model is based off using a PEC Tools 6 inch 4R Rigid Certified Rule (402-006CT) . The rule width is 0.717" and thickness is 0.043" This model is based on this size of rule. You may have to modify the slot to fit the ¾" rule you are using. It is captured in place with a cover plate that is held in with (4) #6-19 rolling thread screws for plastic. I only print with PETG but I am sure you can print in any material you desire. This model was printed using 0.2mm Quality print setting with 30% infill. Also included a gage block just for fun. I hope this helps others.