Fels Naptha Bar Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for Fels naphtha soap, so you can scrub stains without your hands getting covered in soap.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 113
- Wydruki
- 1
- Wyświetlenia
- 717
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Holds a bar of Fels naptha laundry soap. Holes in the bottom for soap to dry. Print one of each: screw, soapslider, and soapholder. Use a ¼-20 bolt (what I had on hand) through the “screw” part (basically a thumbscrew), apply heat to set it in, I pushed in with a soldering iron after pre heating the bolt with a torch. A common plumbing oring I found in my garage fits on the inside face of the thumscrew, but probably isn't necessary.
Dip 1cm of the bar in water for a short time until it's soft enough to push the “fingers" on top of the sliding part into the end of the soap.
Update: slider2 designed with a larger hex opening for the ¼-20 bolt that should fit without heating, and designed to grip soap from the sides. Has not been tested yet.