Fels Naptha Bar Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holder for Fels naphtha soap, so you can scrub stains without your hands getting covered in soap.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 113
- Makes
- 1
- Views
- 717
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
Holds a bar of Fels naptha laundry soap. Holes in the bottom for soap to dry. Print one of each: screw, soapslider, and soapholder. Use a ¼-20 bolt (what I had on hand) through the “screw” part (basically a thumbscrew), apply heat to set it in, I pushed in with a soldering iron after pre heating the bolt with a torch. A common plumbing oring I found in my garage fits on the inside face of the thumscrew, but probably isn't necessary.
Dip 1cm of the bar in water for a short time until it's soft enough to push the “fingers" on top of the sliding part into the end of the soap.
Update: slider2 designed with a larger hex opening for the ¼-20 bolt that should fit without heating, and designed to grip soap from the sides. Has not been tested yet.