1 / 1
Raspberry camera stepper_pan manual_tilt camera holder — zdjęcie 1

Raspberry camera stepper_pan manual_tilt camera holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Camera holder can be used for any Raspberry flat ribbon cable camera. It fits directly onto cheap 28BYJ-48 motor shaft.

Ocena
0 / 5
Polubienia
1
Pobrania
14
Wydruki
0
Wyświetlenia
657
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Camera holder can be used for any Raspberry flat ribbon cable camera. It fits directly onto cheap 28BYJ-48 stepper motor shaft (4096 steps/rotation). Attached OpenSCAD file M5_3.scad allows you to change eg. vertical height, or make it tighter on stepper shaft (d=.04 means that in total 0.08mm space is between M5_3 and stepper motor shaft in any direction). This is a no_screw/no_glue model, tilt working with friction.

You can fixate stepper motor with shaft upwards best with clamp, or a bit of superglue.

M5_3 directly fits onto motor shaft, insert (4.9mm ⌀) flat_holder into its top (5.1mm ⌀) hole, then insert flat ribbon cable into flat holder and add camera. After camera is fixated on flat ribbon cable, best pull back as far as possible so that Raspberry camera touches flat holder.

Camera holder allows for manual tilt. Example code for controlling stepper motor and connection diagram can be found in this forum posting:
https://forums.raspberrypi.com/viewtopic.php?p=2073802#p2073802

Example Raspberry v3 camera fast autofocus demo video created with pan camera holder described in that posting (+250/+150/+130/-530 steps and repeat):
 

 

Single layer number signs used in the video published here:
https://www.printables.com/model/176000-single-layer-numbered-sign

Tagi