1 / 1
Raspberry camera stepper_pan manual_tilt camera holder — image 1

Raspberry camera stepper_pan manual_tilt camera holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Camera holder can be used for any Raspberry flat ribbon cable camera. It fits directly onto cheap 28BYJ-48 motor shaft.

Rating
0 / 5
Likes
1
Downloads
14
Makes
0
Views
657
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution

Camera holder can be used for any Raspberry flat ribbon cable camera. It fits directly onto cheap 28BYJ-48 stepper motor shaft (4096 steps/rotation). Attached OpenSCAD file M5_3.scad allows you to change eg. vertical height, or make it tighter on stepper shaft (d=.04 means that in total 0.08mm space is between M5_3 and stepper motor shaft in any direction). This is a no_screw/no_glue model, tilt working with friction.

You can fixate stepper motor with shaft upwards best with clamp, or a bit of superglue.

M5_3 directly fits onto motor shaft, insert (4.9mm ⌀) flat_holder into its top (5.1mm ⌀) hole, then insert flat ribbon cable into flat holder and add camera. After camera is fixated on flat ribbon cable, best pull back as far as possible so that Raspberry camera touches flat holder.

Camera holder allows for manual tilt. Example code for controlling stepper motor and connection diagram can be found in this forum posting:
https://forums.raspberrypi.com/viewtopic.php?p=2073802#p2073802

Example Raspberry v3 camera fast autofocus demo video created with pan camera holder described in that posting (+250/+150/+130/-530 steps and repeat):
 

 

Single layer number signs used in the video published here:
https://www.printables.com/model/176000-single-layer-numbered-sign

Tags