Czech Koruna coin pocket holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small coin holder for Czech Koruna coins, made for carrying in your pocket. Holds 4 coins of each value.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 1108
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Description
Not much to talk about, it's a pocket coin holder/dispenser for Czech Koruna coins. It'll hold around 4 coins of each value, maybe 5 for the thinner coins.
Dimensions:
- Length: 80.4mm
- Width: 53.7mm
- Height: 20mm
I also have a Euro version of this: https://www.printables.com/model/377634-euro-coin-pocket-holder
Additional, non-printed parts
This print requires 6 springs and 4 screws. The screws are M3 countersunk screws, the length can be either 16 or 18mm. Screws can't be larger than 18mm otherwise they'll stick out of the bottom and/or break the parts.
The springs are small compression springs, with a wide diameter of 0.6mm, outside diameter of 12mm, and length of 20 or 25mm.
These springs are a perfect match for this (select the sizes mentioned above): https://www.aliexpress.com/item/1005004196158892.html
Printing and post processing:
- No supports needed
- Recommend lightly sanding surfaces which will interface with one another (where the base joins with the top)
- If your print is prone to zits and blobs, sand these down too, otherwise the coins and discs will snag and not move properly
- Alternatively, the base and top can be glued together rather than screwed together. This will, however, prevent the coin discs and springs from being removed without breaking it