Czech Koruna coin pocket holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small coin holder for Czech Koruna coins, made for carrying in your pocket. Holds 4 coins of each value.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 95
- Makes
- 0
- Views
- 1,112
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
Description
Not much to talk about, it's a pocket coin holder/dispenser for Czech Koruna coins. It'll hold around 4 coins of each value, maybe 5 for the thinner coins.
Dimensions:
- Length: 80.4mm
- Width: 53.7mm
- Height: 20mm
I also have a Euro version of this: https://www.printables.com/model/377634-euro-coin-pocket-holder
Additional, non-printed parts
This print requires 6 springs and 4 screws. The screws are M3 countersunk screws, the length can be either 16 or 18mm. Screws can't be larger than 18mm otherwise they'll stick out of the bottom and/or break the parts.
The springs are small compression springs, with a wide diameter of 0.6mm, outside diameter of 12mm, and length of 20 or 25mm.
These springs are a perfect match for this (select the sizes mentioned above): https://www.aliexpress.com/item/1005004196158892.html
Printing and post processing:
- No supports needed
- Recommend lightly sanding surfaces which will interface with one another (where the base joins with the top)
- If your print is prone to zits and blobs, sand these down too, otherwise the coins and discs will snag and not move properly
- Alternatively, the base and top can be glued together rather than screwed together. This will, however, prevent the coin discs and springs from being removed without breaking it