Olympus OM D E-M10 Eyecup Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
replacement eyecup for lost original
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 754
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix (combining of) 2 different STL Files. I did this using my very rudimentary knowledge of Tinkercad.
www.thingiverse.com/thing:2985864
and
www.thingiverse.com/thing:3417712
Two reasons for doing this is the first stl had very sharp edges that when wearing camera on my neck would cause painon my chest if i was wearing a tee shirt. The second STL did not have way to attach without glue? The second reason is that original Eyecup provided by Olympus for this camera is a little loose and very easy to lose (which I did) and replacements are very expensive
I printed with supports using PRUSA slicer and PLA. Did not try without supports or is any other filament type.
To install it, it drops down over the viewfinder. It is a tight fit so go slow until it seat all the way down.