FLSUN QQ-S Pro ADXL345 accelerometer mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Accelerometer mount for QQ-S Pro to be used with klipper. May work with FLSun Q5
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 583
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
From Thingiverse:
Couldn't find any plug and play ADXL345 holder, so i designed my own. It's designed to be used in place of the stock probe, so the only additional thing you need (obviously other than the adxl345 itself) it's a neodymium magnt 20x10, which can be temporarily unscrewed from the probe, and a couple of screw. However, i suggest to buy a second magnet to avoid wear on the probe screw hole.
This design comes in 2 variants:
- Generic ADXL345 pcb (GY-291 module), which is the one i had and personally tested
- Genuine Adafruit ADXL345 module, which i couldn't test.
The Adafruit one has been realized using the official datasheet, so dimensions should be fine, but again, i can't assure.
if you have the GY-291 generic module, you will need standard m3 screws, if you have the Adafruit one, I'm not sure, but i suppose you will need M2.5 ones.
The mount has been tested with great results on Klipper's resonance test.