Camera mount for Logitech C910 on Loc line
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've been using a Logitech C910 as my Octoprint camera for as long as I've been using Octoprint.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 1026
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I've been using a Logitech C910 as my Octoprint camera for as long as I've been using Octoprint. I've had a bunch of different ways to mount the camera, and this is yet another.
Once all the stock mounting junk is removed from the C910, there is a loop in the back that fits a 20mm long M4 bolt. This thing mounts to that and fits on the end of Loc-line (aka "flex pipe")
Two versions are included, the original "in line" version, and my right angle version which is what I wound up using. Note that the red inline version in the photos is an earlier design which wasn't quite as nice looking, so I redesigned it and that's the version available.
Print instructions
Category: 3D Printer Accessories Summary
I've been using a Logitech C910 as my Octoprint camera for as long as I've been using Octoprint. I've had a bunch of different ways to mount the camera, and this is yet another.
Once all the stock mounting junk is removed from the C910, there is a loop in the back that fits a 20mm long M4 bolt. This thing mounts to that and fits on the end of Loc-line (aka "flex pipe")
Two versions are included, the original "in line" version, and my right angle version which is what I wound up using. Note that the red inline version in the photos is an earlier design which wasn't quite as nice looking, so I redesigned it and that's the version available.