DeWalt DCD796 holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A below the shelf holder for the DeWalt DCD796 drill/driver.
- Ocena
- 0 / 5
- Polubienia
- 38
- Pobrania
- 226
- Wydruki
- 0
- Wyświetlenia
- 1644
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A holder for the DeWalt DCD796 drill/driver. To be mounted below a shelf. Holds the drill snug and safe, even with the big 5 AH batteries. Mounts with two screws to avoid turning.
The reason for the 10 cm wide to is to make sure the wide battery doesnt collide with the wall or any tools mounted beside it.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
100% (very little infill)
Filament: 3Deksperten PLA Black
Notes:
I printed it with the narrowest end down, to avoid support on the inside. That leaves supports only on the rear of the square plastic mounting bracket, where any residue cant be seen.
Category: Tool Holders & Boxes