The Black Hornet p1 - a slightly overengineered soap bubble wand (10cm diameter)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
soap bubble wand (10cm diameter)
- Ocena
- 4,8 / 5
- Polubienia
- 43
- Pobrania
- 263
- Wydruki
- 4
- Wyświetlenia
- 1851
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Welcome to my slightly overengineered soap bubble wand called “THE BLACK HORNET p1” (approx 10cm diameter)
( Please refer also to “THE BLACK HORNET p2” which is an addition to this).
This soap bubble wand came to life by a request of the Spanish soap bubble artist Pablo Muñoz Garcia - thanks Pablo for this nudge!
A design goal was to avoid support structure. In the end, I did not succeed totally, but I did for the most part of it. I wanted to get to the classic design of a balloon wand as close as possible - especially the fine rips were my boss fight. The advantage with this design (the ring devided by its midplane) is, that you can print the fine rips without support and the best quality.
It took me quite a while and some unhappy print experiences but here is the ‘finalized’ version.

The wand structure consists of four parts ( please refer to the colored picture above):
- Part One and Part Two - upper ring (green) and bottom ring (red)
the soap bubble fluid carrier ring, aka the upper (green) and the bottom (red) ring. Those two parts are glued together. In order to glue them together in a perfect way, there is an additional glueaid part (blue) included. - Part Three – the bow (yellow)
the bow was a nose at its bottom. This nose is sticked and glued into the glued ring pair. - Part Four – the handle (gray)
The handle is glued together with the bow at their overlapping areas (as shown in picture). The handle does have two holes, where you can glue in round 10mmx2mm magnets – those magnets are not necessary but very nice to fix the upcoming “THE BLACK HORNET p2” (to be released) onto the “THE BLACK HORNET p1” easily.
Some thoughts & hints:
- I recommend to print the bow upwards (nose aiming to the ground). This needs support, yes, but the outer surface is always good – downside, you have to get rid of remaining support structure at the area of the bow, where it it is glued with the other parts – sand paper will be your friend.
- I used 0.15mm and 0.2mm layer heigt. I personally prefer the 0.15.
- the design process was made with PLA Prusament Galaxy Black
How to built:
- print all parts, included the glued aid
- position the bottom ring with the rough side upside down into the glue aid – the smooth surface is now facing you
- spread glue onto the smooth surface of the upper ring (you can use a small needle to spread the glue onto the whole surface) and glue the upper ring onto the bottom ring using the glueaid – CAUTION: Do not use to much glue, because the glue is pressed outside.. this could cause your ring pair glued into the glue aid à unhappy glue experience
- spread glue onto the nose and the surrounding contact area of the bow and insert the nose of the bow into the curved hole of the glued ring pair
- spread glue to the contact areas of the bow a glue and press this onto the corresponding area of the handle
I would love to see printed copy of this, even “in action” photos would be highly appreciated. There is always room from improvment - please let me know if oyu have an idea. So take care and have fun out there!
Enjoy your copy of the “THE BLACK HORNET p1