Jan Heynen's DIY GPS case with screen centre

This version corrects a few minor errors in previous prints with also option for Al Hop's suggestion to centre the screen.   Note to centre the screen you need to carefully put a knife between the display and PCB beneath.  I managed to crack the screen on my attempt so do so at your own risk.  (which is why there is two trim variants, the offset one requires no repositioning of screen)  No need to put double sided tape as the sticky goo keeps the screen in the new position well enough (assuming you are going to epoxy).    The ribs on the inside trim hold the screen away from Polycarbonate and hopefully help with air bubble removal when filling with potting epoxy.    Inside means inside the Polycarbonate window.    You can also put the trim outside the Polycarbonate which was a previous design idea to minimise air bubble removal..the downside of this is after time the trim gets broken off so need to replace.    Please see previous print versions for more detailed instructions.      

Here is short time lapse video of the 3D print which may help show orientation/supports etc.  Note print quality shown in video is lousy as PETG strings a lot when parking the print head each layer to take the time lapse.