Print-in-place Tool Case for Mini Pick and Hook Set
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small toolbox for a mini pick and hook set I found at a national tool store (Harbor Freight).
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 164
- Wydruki
- 1
- Wyświetlenia
- 1031
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This small toolbox features a print in place hinge and should fit on square beds 200 mm or greater. It's designed to print flat on the exterior of the case without any supports. I would not print with support or brims turned on as that could affect the hinge and require clean up.
If you are getting corner lift, manually add discs with a shared brim to hold the corners down. Additionally there is a cavity for a pair of latching magnets. You can add a pause M0 at the right height (layer before it starts to close/prints the top) so that you can insert them. Don't forget to use CA glue and hardener to keep them in place before resuming the print, otherwise you run the risk of the magnet popping out on to your nozzle when you resume your print.
Magnet Dimensions: 8mm x 3mm
Link to tools: Harbor Freight #63697 - Mini Pick and Hook Set