1 / 2
Xiaomi Mi Air Purifier 2S replacement fans — zdjęcie 1
1 / 2

Xiaomi Mi Air Purifier 2S replacement fans

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement or spare fans for the Xiaomi Mi Air Purifier 2S

Ocena
0 / 5
Polubienia
14
Pobrania
95
Wydruki
0
Wyświetlenia
1567
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Problem

Turns out that tilting your Xiaomi Mi Air Purifier 2S while running is a bad idea, as it broke a few fan blades.

The purifier has 2 fans, mounted concentrically on the same motor. Spares are ~26 EUR each on Aliexpress, plus shipping … doesn't make much sense, whole machine was ~100 EUR new. So, let's print replacements !

Print settings

You want this in PETG or ABS, sturdy and printed as symmetrical as possible.

  • 4-5 perimeters
  • 20-40% infill (choose one of the symmetric ones, like triangles)
  • scattered seam (you don't want any imbalance)
  • place both fans mounting side up
  • no supports 😎

Additional notes

The motor shaft is 8 mm. My design has the fan hole at 8.1 mm, which should be a tight fit - you don't want it too tight or too loose, just enough play as the pins will hold the blade in place just fine. Depending on your material/printer/settings/etc, you might need to run an 8 mm drill bit through the fan blades in order to get it installed.

When mounting, be sure to align the indents with the two pins mounted on the motor shaft. Ensure there's clearance between the motor body/mount and the blades, nothing should rub. Pay attention, the upper nut and lower cone are reverse threaded.

Disassembly instructions

Watch these to understand how to disassemble the purifier:

 

Tagi