Mario Pipe Pen Holder (Easy Print)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Andre Stadler's Mario Pipe Pen Holder, with the base of the pipe cut off, for a support-free print.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 148
- Wydruki
- 1
- Wyświetlenia
- 783
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of Andre Stadler's Mario Pipe Pen Holder. I cut off just the bottom of the base of the green pipe section to allow for a support free print of the pipe when printed top-side down.
This does mean that if you ever lift the pipe from the block, you're gonna have a bad time, but that can be solved by either gluing the parts together, or just not doing that.
I found that when printing on my AnkerMake M5, whether it was the filament I used or just the model, I had to slow the pipe print speed down to 3x (150mm/s), but the base prints fine at 5x (250mm/s).
Images shown printed in Overture Green & Overture Brown PLA, base was also coloured using a black sharpie in between bricks, although this bled quite a lot so maybe not the best idea.