Mario Pipe Pen Holder (Easy Print)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of Andre Stadler's Mario Pipe Pen Holder, with the base of the pipe cut off, for a support-free print.
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 148
- Makes
- 1
- Views
- 783
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Share Alike
This is a remix of Andre Stadler's Mario Pipe Pen Holder. I cut off just the bottom of the base of the green pipe section to allow for a support free print of the pipe when printed top-side down.
This does mean that if you ever lift the pipe from the block, you're gonna have a bad time, but that can be solved by either gluing the parts together, or just not doing that.
I found that when printing on my AnkerMake M5, whether it was the filament I used or just the model, I had to slow the pipe print speed down to 3x (150mm/s), but the base prints fine at 5x (250mm/s).
Images shown printed in Overture Green & Overture Brown PLA, base was also coloured using a black sharpie in between bricks, although this bled quite a lot so maybe not the best idea.