Drawer Handle Router Template
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple router template for routing draw handles in the top of drawer fronts.
- Ocena
- 5 / 5
- Polubienia
- 174
- Pobrania
- 776
- Wydruki
- 1
- Wyświetlenia
- 3551
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
A router template I made for routing simple draw handles in tool drawer fronts in my workshop.
Clamp it to your drawer front with thin double-sided tape or using the masking tape/CA Glue technique, then use an edge/trim straight bit in the router table or plunge/trim router, making sure the guide bearing runs along the edge of the template without cutting it.
I generally finish the handle off with a round-over bit to remove sharp edges, but sanding will work fine too.
There is a small window in the middle so you can line-up the template to a line on the drawer front to make sure it's aligned.
Notes:
I printed this with PLA without any supports, using 15% infill. I added the holes to minimise filament use, but it still strong enough for the job.