Muin Solder Fume Extractor Riser Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Raises the Muin Solder Fume Extractor up 120 mm bringing it closer to the top of a desktop vise.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 139
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I do a fair amount of soldering work using my desktop vise. I purchased a Muin Solder Fume Extractor (available on Amazon) & found that it was fine for soldering items on the desktop but not when they are in the vise. So I designed this simple riser to raise the Extractor up 120 mm so that it was at a height equal to my vise. The riser has depressions for the Muin's four feet and when the Extractor is in the riser, it fits snugly into the top.
I printed this with supports and then left the supports in my print but you can easily pull the supports out from beneath the unit. Standard MK3S+ settings. Print shown was made using eSun Yellow PLA+ filament.
If you need to adjust the height for a lower rise, simply cut off from the bottom of the unit rather than scaling as scaling will adversely affect the depressions for the unit on the top.