Tair 3 Tube Ring Inserts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Inserts that allow a Tair 3 to be used with standard 90mm Skywatcher tube rings.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 626
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution
Quick and Dirty. Allows you to use the Tair 3 with Skywatcher 80-90mm tube rings. In order to use the print effectively you need to remove the cocking mechanism (this is just 4 screws holding it in place).
You need to cock the mechanism to the aperture is fully open and then use stepdown rings to get the best F-ratio. I also highly recommend lining the inside of the insert with flocking material to increase friction. I've used this setup successfully to image with the tair 3 and a dedicated astro camera.
There are 3 inserts which correspond to the 3 different diameters of the tair 3 allowing you to fit them best for your setup.