Creality Filament Spool Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An insert for Creality filament spools. Should fit over any spool holder measuring 36mm in diameter or less.
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 151
- Wydruki
- 1
- Wyświetlenia
- 897
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I am very new to 3D printing and don't now a lot, but I do know that wobble and drag is bad! After sitting through print after print of a squeaking, throbbing filament wheel, I thought to myself “I bet I can make this a bit more smooth.” Viola! My design for a filament spool insert that fits Creality filament spools, made for the Ender 3 v2 filament holder. Though I'd imaging that it would work on any spool with similar sized hole (measurements below).
Print two total (one for each side of the spool).
Plug diameter: 55.5mm
Hole diameter: 36.25mm
Made in Tinkercad (My first full design!)
Printed with a 0.4mm nozzle set to 0.20mm layer height.