Replica of Toyota Part 75833-14030 Panel, Lower Back Finish - for MK3 Supra
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Trim pieces to help secure the taillight centerpiece from a facelift Mk3 Supra.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 727
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These trim pieces are easy to break when removing the center taillight piece. The original pieces are aluminum with steel mounting studs. They included models are:
- 75833-14030 - Left side (#2 in the diagram)
- 75832-14060 - Right side (#2 in the diagram)
- 75849-14020 - Left end pad (#3 in the diagram)
- 75847-14050 - Right end pad (#3 in the diagram)
Print these with a strong, vibration-resistant filament. I left stalks where the bolt studs should be. I've also included a model of an m5 flange nut. I will attach them by threading an gluing the nut on.
The end pads are originally rubber. I recommend a soft TPU.
When mounting, consider that the outer mounting holes must be water-tight. Originally, Toyota used a foam washer for this. If you're printing this part, you should find your own water-tight solution (the end pads are for vibration isolation only).