*Updated* HMG7 Creality Single Gear Rear Mount (Remix V2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
remix to allow the stock Creality extruders (metal and plastic) to be fitted to it a lot easier
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 66
- Wydruki
- 1
- Wyświetlenia
- 546
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
the first time i printed this i had a hell of a time trying to put it together as i had to have the tension adjustment bolt in place and one of the motor screws as the tension adjustment bolt blocks it being put in or removed and when i did get it together i would not have been able to load filament as there was not enough room to let the end of the lever move so here is a remix to fix this
now updated in Fusion 360 for a much neater model
Changes (from the original R 1/2.1 version):
-cut left side for lever arm, filleted and chamfered to match
-lowered right side for plastic extruder body clearance, filleted and chamfered to match
-cut hole for tesion screw, added .25mm chamfer
-added 0.5mm to the angled face next to the tension bolt hole so it didnt end up too thin, then fileted and chamfered edges to match
-noticed that the filament path hole was slightly off centre (maybe .2-.3mm), adjusted it a little so i would stop noticing it lol
for printing follow original instructions
Assembly Order:
1. remove all screws from the extruder body and place it in the mount
2. put in the 3 screws that secure the extruder and motor to the mount
3. attach the extruder arm and then put the spring in
4. lastly put in the tension adjustment screw
