1 / 7
Plywood Furniture Connectors — zdjęcie 1
1 / 7

Plywood Furniture Connectors

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Create furniture from pieces of plywood using these connectors

Ocena
0 / 5
Polubienia
196
Pobrania
701
Wydruki
1
Wyświetlenia
4964
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Living Room
Licencja
Creative Commons — Attribution

These connectors can be used to build shelves, storage boxes, desks, and other useful items from pieces of nominal ½ - ¾ inch thick plywood. Each connector consists of an outer piece, a 90 deg angle, an X, a TEE, and one or two inner wedges.  Square ¼ x 20 nuts are pressed into pocket(s) in the outer piece (Tap with a hammer to start and use a pin punch to drive nut until it hits bottom of pocket). The outer and inner pieces are drawn together by flat-head ¼ x 20 machine screws (1 ½ inch length will work for both ½ and ¾ inch plywood, but 1 ¼ inch length is safer for ½ inch plywood). The angles of the outside pieces are 88 degrees and the angles of inner wedges are 90 deg, making the clamping tighter at the ends then in the middle.

Warning: it takes a large number of connectors to make even a simple piece of furniture, so make a design before you begin printing. I print these connectors without supports using PLA filament with 0.3 mm layer thickness, 5 perimeter layers, 5 top and bottom layers, and 20% gyroid infill. 

My grandsons built the LEGO storage unit shown in the Photos. It has no back or diagonal bracing for stiffness, and only the bare minimum number (75%) of connectors was used. After one year of being moved and pushed around, some of the outer pieces have cracked along the 90 degree inside corner shown in the Photos. An inside corner is a known stress riser; however, after many failures I noticed that the connectors all cracked at the interior corner on the same side of the connector. This must be because the slicer is placing all the perimeter seams at that location. To strengthen the connectors, set your Slicer's Seam Position to Random, with Staggered Inner Seams, and paint the seam location on the back side of the connector where the round hole is (see the last photo).

I have also uploaded a chunky design for the connectors that is thicker at the stress point, and  a design with rounded inside corners.

 

Tagi