industrial pipe valve rotary switch 3/4"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
just a 3/4" version of my industrial pipe valve rotary switch for lamps etc
- Ocena
- 5 / 5
- Polubienia
- 32
- Pobrania
- 107
- Wydruki
- 1
- Wyświetlenia
- 693
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
A rotary pipe valve time switch (yes i could have made is like an actual valve but longer and much harder to print out).
print the 3 parts
non printed part
rotary switch - amazon, ali express etc
heat shrink tubing
tools
knife and or stripper (no not that kind)
soldering iron
solder
heat gun or lighter (for shrink tubing)
Do not do this when lamp is plugged into power (have to say just in case)
Split the wire where you want to put the rotary switch connections (make the split about at least 3 inches (8cm) long. Using wire cutters carefully cut through ONLY THE HOT (smooth) WIRE, making sure that the cutters do not cut the Neutral wire's insulation. Solder the rotary lines to each end of the cut wire (after you stripped off insulation.
heat shrink connections
works with .4 or .6 nozzle
.2 or .3 resolution