Bottle Dryer v3 Snap-System

check out the other versions

Attention the dryer will not work if the opening of the bottle or cup is smaller than 65mm

for bottles and cups with a smaller opening, have a look at version 1 and version 2


a lot of people have messaged me and said we like your bottle dryer it works very well but for protein shakers and bottles with a wide mouth it's pretty shaky

so i designed version 3 which adjusts with a spring mechanism
 

the version 3 has hinges for the spring-loaded arms that allow it to adapt better to the shape

i made 2 versions the standard version with a height of 5mm and a reinforced version with a height of 6mm here the hinge and the arms are stronger

Depending on how well your setup is coordinated, it could be possible that you need support in the area of the hinges

with well-optimized bridging, this is not necessary

I have printed the models in PETG and ABS so far, but I would recommend PETG

the models can be printed with a layer height  from 0.1 to 0.3 without any problems

My Print settings

Perimeter: 5
Infill: 20%
Top Layer: 5
Bottom Layer: 5
Layer Height: 0.3