1 / 14
Futaba Monitor Mount — zdjęcie 1
1 / 14

Futaba Monitor Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Overview NOTE This is V1, See V2 for the redesign !

Ocena
0 / 5
Polubienia
8
Pobrania
41
Wydruki
0
Wyświetlenia
579
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Overview

NOTE This is V1, See V2 for the redesign !

I was really disappointed with the Futaba T8J Monitor mounts I have found so far, so I decided to design my own. I have designed this primarily for use with the Flysight Black Pearl monitor but I will be modifying this design in the future to make it more flexible. You can use the version without the back support if your device doesn’t line up, I will probably tweak the design a little to soften some of the hard edges and also change the fixing hole to a slot to allow for some adjustment.

Notes

  • It has been designed to be printed in two parts that glue together with CA or Superglue.
  • Once printed and glued the mount can be attached to the controller with 2 tie wraps.
  • There are two versions included - One has the right angled supporting backplate.

Print instructions

Category: R/C Vehicles Summary

Overview

I was really disapointed with the Futaba T8J Monitor mounts I have found so far, so I decided to design my own. I have designed this primarily for use with the Flysight Black Pearl monitor but I will be modifying this design in the future to make it more flexible. You can use the version without the back support if your device doesn’t line up, I will probably tweak the design a little to soften some of the hard edges and also change the fixing hole to a slot to allow for some adjustment.

Notes

  • It has been designed to be printed in two parts that glue together with CA or Superglue.
  • Once printed and glued the mount can be attached to the controller with 2 tie wraps.
  • There are two versions included - One has the right angled supporting backplate.

    Print Settings

Printer Brand: Prusa

Printer: i3 MK2S

Rafts: No

Supports: No

Resolution: 0.15

Infill: 20%

Filament: Any PLA Post-Printing

Attach Back Plate

Simply glue using CA glue the backplate to the base using the locating lugs and holes. This should make a really strong bond that keeps the back plate rigidly held on.

Version with back plate

Final Glued assembly

Tagi