Sunlu, Tecbears & Giant Arm Filament Spool Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An insert for Sunlu, Tecbears & Giant Arm filament spools. Should fit over any spool holder measuring 36mm or less.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 106
- Wydruki
- 2
- Wyświetlenia
- 759
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I am very new to 3D printing and don't now a lot, but I do know that wobble and drag is bad! After sitting through print after print of a squeaking, throbbing filament wheel, I thought to myself “I bet I can make this a bit more smooth.” Viola! My design for a filament spool insert that fits Sunlu, Tecbears & Giant Arm filament spools, made for the Ender 3 v2 filament holder. Though I'd imaging that it would work on any spool with similar sized hole (measurements below).
Print two total (one for each side of the spool).
Plug diameter: 72mm
Hole diameter: 36.25mm
Made in Tinkercad
Printed with a 0.4mm nozzle set to 0.20mm layer height.