Airsoft Silencer, type L96
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It screws into the outer barrel in replacement for the end-cap.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 471
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a slightly modified remix of the original found on thingiverse, the thread on that one was very large so it could not enter the barrel. I reduced the scale to around 80%, cut some of the outside thread as it was also too long and made the hole larger as it would have been to narrow for it to work.
Print settings:
layer heigh: 0.1mm, 0.2 should also work
Material: PLA, PETG should also work
Brim: yes
Supports: yes
Raft: no
original design was meant for Well MB01,Well MB02,Well MB03,Well MB04,Well MB05, I only tested my design for MB03
I suggest turning the model upside down as it would only need supports for the first 10ish layers.