Airsoft Silencer, type L96
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It screws into the outer barrel in replacement for the end-cap.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 72
- Makes
- 0
- Views
- 471
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial
This is a slightly modified remix of the original found on thingiverse, the thread on that one was very large so it could not enter the barrel. I reduced the scale to around 80%, cut some of the outside thread as it was also too long and made the hole larger as it would have been to narrow for it to work.
Print settings:
layer heigh: 0.1mm, 0.2 should also work
Material: PLA, PETG should also work
Brim: yes
Supports: yes
Raft: no
original design was meant for Well MB01,Well MB02,Well MB03,Well MB04,Well MB05, I only tested my design for MB03
I suggest turning the model upside down as it would only need supports for the first 10ish layers.