MN90 - D90 Rear Roll Bar with Tire Carrier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
MN90/99 D90 Rear Roll Bar with and without tire carrier.
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 399
- Wydruki
- 0
- Wyświetlenia
- 1589
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
MN90/99 D90 Rear Roll Bar with and without tire carrier. You'll need to get quite a bit of support for this to all work; but it turned out really well. Both options are included in the file.
You'll need 2 x M2 15mm or better to hold the roll bar onto your truck and one M2 (10mm or better) if you want to hold the tire on as well.
Update: 7/19 - Add a middle support for the top bar and better supports for the tire carrier into the bar that supports it. Also added fillets to makes the pieces look welded.
Print instructions
Supports are required; though I did get away without them for the top most bar. 0.2 or 0.35 work well depending on the detail/smoothness you're looking for.